CyClone 866F Spezifikationen PDF herunterladen (Seite 18)

FEATURE PROGRAMMING

System Operation

Description of Programmable Features

NOTE: When you select any of the 8 programmable features, the siren will

chirp the same number of times as the feature you just selected, and the

Status LED will also ash the same number of times. When exiting the

Feature Selection Menu, the Status LED will ash the same number of

times as the Manual Disarm Code and then the siren will chirp 3 times.

1. Auto Arm Sensor Enable. Allows you to choose either a single sensor

or both sensors to be active when the 866F automatically Arms. You

can choose your preferred “Single Sensor” in Feature No. 3 (see below).

2. Shock Sensor “Full Trigger.” When set to OFF, even hard shocks

produce only Warning Chirps. Of course, you could just turn off the

shock sensor Full Trigger (10/30s siren blast) simply by turning the sen-

sitivity POT all the way to the left (see pages 9-10). But this program-

mable feature allows you to disable the Full Trigger while keeping your

desired Full Trigger level set on the POT. This is useful if you some-

times wish to disable the Full Trigger and then later re-enable it. (SBS

still limits “hard shock” triggers—see Feature No. 5 below.)

3. Single Sensor. Allows you to choose either the Tilt sensor or the Shock

sensor to become active during these two conditions: (1) Auto Arm and

(2) Button-2 Arming. (This feature is tied to feature No. 1 above.)

4. Duration of Full Siren Blast. You can program the siren to go off

for either 10s or 30s. The Full Siren Blast goes off during a Shock Sen-

sor Full Trigger, Ignition Switch Trigger, Digital Tilt Trigger, Panic Si-

ren mode, and when the power is cut to the system while Armed (siren

sounds via Cyclone’s internal backup battery).

5. Sensor Bypass System (SBS). SBS prevents the 866F from becoming

a public nuisance. With SBS on, the system will individually bypass the

Tilt sensor, Shock sensor (Full Trigger only), or the Ignition sensor after

each sensor triggers 5 times. For example, if the Tilt sensor triggers 5

times, SBS will disable it but the Shock and Ignition sensors remain ac-

tive (until they too individually trigger 5 times). If noise pollution is not

an issue for you, SBS can be turned off.

6. Auto Arm. Set to ON by default. When programmed ON, Cyclone

will Arm itself automatically 5 minutes after the Ignition goes off.

(Turning the Ignition off is what activates the Auto Arm timer. Cyclone

will not Auto Arm at all if you merely Disarm with the transmitter.)

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 24

Keine Kommentare

CyClone 866F Spezifikationen Seite 18